Hello, i' am a portuguese student, and I have to do for my final project of degree, a centrifugal pump,

I am using the flow simulation, but i can not simulat because my pc frezze... and returns messages  "solidworks resource monitor, say available system memory is low".

to creat mesh is like 3 hours, and in estimated calculation time left is 200h!!!!!!

i have two rims 4gb 1333hz and 2 rims 2gb 1333hz.  i can put, 2 rims of 8gb 1600 hz, and one rim of 4gb of 1333hz, in total I would have 20gb on 1333hz...that is enough?

my hard disk is a problem, i think...is  a  "WD 1TB 5400 RPM 64MB Cache SATA 3.0Gb/s 3.5" Internal Hard Drive Bare Drive", should I change ? to ssd?

is image, is my model....i have a assembly of two parts...  please help me....