12 Replies Latest reply on Sep 18, 2015 12:33 PM by Vio Vivio

    Interference between parts

    Vio Vivio

      Hello,

       

      I'm trying to do a FEM analysis in order to see the deformations that occur between two parts.

       

      If I use Free drag with collision detection I get a small interference, that messes up the analysis.

      Due to the shape of the parts is kind of hard to do in SW2014 a tangent mate, but even if it behave properly in case of nonlinear analysis it give the message the: The parts are not in contact.

       

      If you have any suggestions about how to put the parts in contact without interfere with one another, please share it !

       

      pic3.jpg

       

      pic1.jpgpic2.jpg