I have this small part that's having problem flattening. It seems that one of the hems is having issues, but I'm not sure why. The one symmetrical to it seems to be fine though.
Any help will be appreciated.
Check this out.
I hope it will solve your problem.
No more errors now to your part.
Hi, do not use split. Try use Edit hem width.
Oh, right. But after highlighting an edge, and then clicking 'Edit Hem Widths', I get an error saying 'The sketch is invalid'. This happens to both 'inside' and 'outside'.
I dislike the Edit Sketch option for bends. I prefer to use a notch or two as is sometimes required, sometime it's only .001 deep. The Offset Bend option is helpful sometimes too.
Edit sketch 184 & 186 add a little space at the end of the line
Retrieving data ...