I have a Forming Tool on top of a jog. In the Flat Pattern, the Forming Tool is suppressed because SW can't unfold it, so it does not show up on a drawing. How would I show the placement of the forming tool on a drawing? File attached.
Give this a shot Mark. I converted the sketch entities from the form tool sketches onto the face of the bend (joggle side). I couldn't get sketch to show up in a drawing so while in the flat pattern I converted a new sketch from the "transformation" sketch then did a shallow cut extrude. You may have to flip the flat pattern in a drawing to make sure the sketch is on top.
Use your Configurations to go from formed to flat.
Thanks for giving it a try Dennis. The only thing I could come up with is to create a sketch in the drawing flat pattern view. Not parametric, but a quick fix.
Retrieving data ...