2 Replies Latest reply on Aug 4, 2015 2:50 PM by Tom dunn

How do I put my BOM on a separate page

Larry Wagner Aug 4, 2015 2:39 PM

My BOM is too big to fit on the page with the assembly. How do I the BOM on a separate page and keep the balloons linked?

Re: How do I put my BOM on a separate page

Scott Harvey Aug 4, 2015 2:44 PM (in response to Larry Wagner)

Click the row you want to cut the table into to. Right Click and choose Split (either above or below this row)

Then Click and drag the gray box with the arrows in the top left of your bom down to the 2nd sheet.
Like Show 1 Likes(1)

Actions
- Re: How do I put my BOM on a separate page
  
  Tom dunn Aug 4, 2015 2:50 PM (in response to Scott Harvey)
  
  Create your second sheet. In the feature manager tree select the bom and drag it to the second sheet shown in the feature manager tree. should keep the balloons linked.
  
  Like Show 0 Likes(0)
  
  Actions