2 Replies Latest reply on Aug 8, 2015 8:18 PM by Jaja Jojo

    why is that my simulation data value is not present in my constraints tab when i use design optimization

    Jaja Jojo

      I'm Designing a bio-gas scrubber and i had an issue, could you please help me about this issue, i would like to optimized the copper rod but the simulation data is not available when i add my constraints in the design study but in my static analysis in the sensor  tab the stress value is present.

      Or i can just manually type the value of the minimum or maximum stress

      I attached picture of my design study and static analysis.

      Untitled.png

      Untitled1.jpg