I am trying to create an emboss across a jog in the side of an enclosure. I am close, but the tool is leaving a sliver behind. I have spent too much time on this and need some help.
The files are attached if someone is willing to give it a try.
I am trying to create an emboss across a jog in the side of an enclosure. I am close, but the tool is leaving a sliver behind. I have spent too much time on this and need some help.
The files are attached if someone is willing to give it a try.
I rounded some of the dimensions to smooth it out.
I see your sketches are not fully defined.
I'm guessing that's the issue.