Can someone please advise why my dimensions in a sketch have become too large suddenly. This is only happening in a particular part.
It seems like your arrows have been increased on only 1 part so I would check your document properties on the part concerned (see the attached image and reduce the size of the arrows to see if this makes any difference
It looks like the settings shown below got changed.
My setting have not changed. This is only happening in a particular part. The sizes are correct if a start a new part.
Is this an imported part? or an old part, your settings definitely changed in your template or it could also be a bug ....
It is a new part. My template is still the same.
Then it has to be a bug - send the file to your VAR
Feroz Mahomed: Glen, My setting have not changed. This is only happening in a particular part. The sizes are correct if a start a new part.
I understand that this is only happening in this one part, and unchanged in your part template. But have you checked those settings in this part? Can you post the part here?
The settings in this part are as per my part template.
Changing the settings to less than half my template settings helps. It has to be a bug.
Thanks to all for assisting.
Retrieving data ...