Good Morning,

I am having an issue with a file that I have been working with for quite some time. I created an assembly file and dropped in two of the same parts with different configs and notice that one of the configurations went red. I looked at the part file and turns out that I have greyed out features and sketches that are not useable at all. I have tried suppressing, unsuppressing, roll to the end, and restarting. I even went as far as to have IT look at my registry and get rid of the 2012 stuff, just in case there was compatibility issues.

so my specs are as followed:

SW Premium 2013 x64

SP5.0

I am  running Windows 7 64bit.

I'm trying to find out if there is a solution because there is about 3 months worth of work that Id rather not restart. I have looked through other forum post with the same issue and they are dated back a couple of years and as far as it went in those posts they were "corrupt files". I'm hoping this is not the case and there can be a fix or is a fix now.

Attached is a pic of what I am having and issue about.

Thanks,

Terrance