AnsweredAssumed Answered

Why does dimension snap away from relevant body?

Question asked by Colin Carlisle on Jul 26, 2015
Latest reply on Jul 27, 2015 by Glenn Schroeder

Okay so I am getting seriously frustrated by this and dont know what to do.  I am creating a fab set from tube frame and selecting 1 body at a time and then laying out all relevant details (ie: hole locations, overall dimensions, etc.) and certain bodies will not let me dimension them.  The truth is they do allow me to dimension them, however they are not even close to the actual body that is being dimensioned.  See attached picture, I have tried dimensioning the line, from end lines...Ive tried deleting and updating the cut list.  Ive even tried pulling in the part and selecting the body over again.  This set is for a much more complex assembly and this is the frame aka part 1 that I have to detail...Im losing my mind...suggestions anyone.  Its happening to multiple parts in my multibody part too its not a complete fluke and just one odd ball.