Hi I have just downloaded Draft sight, my problem is so that when I send my drawing over to laser Cotter it says (11 open ends) I can not see any opne lines what do I go?
The open lines are there, however very very small...
You can try to join them by typing Join and making the selection
Can you upload the dwg or dxf????
I do not think that I can upload it here
there is not a the connect all lines.
Michael Frost: I do not think that I can upload it here
Click on the "Use advanced editor" text at upper right, then there will be a link at lower right to attach files.
if you want to see it I can send it by mail
Try converting the lines into polyline and then check.
Retrieving data ...