2 Replies Latest reply on Jul 11, 2015 12:50 AM by Simon Kim

Need some help with a project curve

Simon Kim Jul 10, 2015 5:55 PM

I'm currently working on an Audi R8 tutorial on youtube, and for some reason, my project curve looks different than the one in the video. Here is a picture of the problem:

I want to connect the endpoint of the project curve onto the second curve. Also, here is the link for the tutorial in case it helps - Modeling Audi R8 in SolidWorks 3(53) - YouTube. ~13:00

Audi R8 problem.png 906.3 KB

Re: Need some help with a project curve

Paul Salvador Jul 10, 2015 9:02 PM (in response to Simon Kim)

Simon,.. I'd suggest you check the intersection at 551mm again and/or make sure the top edge of the surface was not trimmed back too far?
Like Show 0 Likes(0)

Actions
- Re: Need some help with a project curve
  
  Simon Kim Jul 11, 2015 12:50 AM (in response to Paul Salvador)
  
  Wow thanks a lot Paul! While looking at your second picture, I realized that my centerline was not straight, so I made it vertical and now the curve looks perfect! Although it wasn't exactly what you suggested, it worked nevertheless Thanks again.
  
  -Simon
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post