AnsweredAssumed Answered

unwanted notch at corner of edge flanges

Question asked by Joseph Sensenig on Jul 9, 2015
Latest reply on Jul 10, 2015 by John Stoltzfus

I have two sheet metal flanges that meet each other, and SW automatically puts a notch in as shown on the flat pattern. What I would like to see is to have the two edges just come together, like a v, with no additional notch at the bottom. Is there a way to accomplish this? I have attached the part file to look at.


Here is the unwanted notch.








What I am looking for would look like this.

notched properly.png