In sheet format, is it possible to make this "all dimensions are in inches" automatic so that it will take unit system applied to the part? We have components some in inches and some in mm..I dont want to edit evry time..
The units are part of the template and not the sheet format you will need to update the template to behave as you require.
If you have one Drawing Template set to inches and the other one set to metric it should work, however you would have to re-load the new drawing template for the changes to be applied.
I would take your standard metric template and do a save as for the new template and when you open the new template also save the sheet format, then you should be ok, but like I said you would have to re-load the new template.
Retrieving data ...