Took me almost half an hour to create this part in SW....
Can someone check and see whats wrong? the mass doesnt match with the correct answer which is d)
Any help is appreciated!
Check your Sketch2 for the Boss-Extrude2 feature
Compare with this
I think your center of the arc is different
ok. I see. I changed it to 15 mm and that basically caused chain reaction with minor remodeling of the recessed area.
Got it now... My fear is its really took 30-45 minutes just to model this... My question is to anyone who passed certification : Does it really take that much to model the part or its just me?
I have a few recoendations for you in order to save time and a more strong design
-- Use convert entities
--Use offset entities
--Use relations to fully define your sketch
Talking about whats wrong with this part i found that the arc was misplaced and in addition when the second arc was drawed it generated an error in dimensions , (Not for Solidworks but for the design intent), here the best way is to use the offset entities feature..
Retrieving data ...