I've some problems to make a variable fillet as show in the picture. I need the 80 mm radius only at the right side.
This is my first project in SW, so probably there are some mistakes with the surfaces or other, i dont know.
I think because the edge you are filleting does not have 2 distinct ends that it doesn't give you the normal variable radius points to set. So my attempted solution involved creating split lines to break the edge into multiple sections, then you can apply the variable fillet as usual. For some reason it wouldn't let me go all the way up to 350 mm around the sides and top, but I set it to 200 successfully and at least you can see my approach. Maybe it will point you in the right direction.
Thanks a lot.
Now i've a similar problem with the solid model. I need a variable fillet as you show below.
EDIT: The radius is 150mm not 350.
Is it supposed to be 150 mm radius here too? There isn't room for that large of a radius.
Retrieving data ...