Hello people,
I did 2 lofts and the result was that. It is merged, but there is a line between the 2 lofts. Can I merge the surface as well?
I also had problems trying to shell It with a thickness of 10mm or greater.
Message was edited by: Gudi 2 Mm
Hello people,
I did 2 lofts and the result was that. It is merged, but there is a line between the 2 lofts. Can I merge the surface as well?
I also had problems trying to shell It with a thickness of 10mm or greater.
Message was edited by: Gudi 2 Mm
Hello,
Can you please attach the part ?
Thanks & Regards,
R.Vignesh
Welcome to the forum.
Regarding your question, have a look here how to remove parting lines on mirrored bodies
And for forum posting please read Forum Posting and Frequently Asked Forum Questions if you have not.
I hope that your model has merged righteously but the thing is, the visual style of the model is in "Shaded with Edges mode" just change the visual style to "Shaded mode" and see. your model will be "ok"
Thanks and Regards
Venkatesh S
Application Engineer
E G S Computers India Pvt. Ltd.
http://www.egsindia.com | http://www.egs.co.in | http://www.egsindia.blogspot.in
I hope that your model has merged righteously but the thing is, the visual style of the model is in "Shaded with Edges mode" just change the visual style to "Shaded mode" and see. your model will be "ok"
Thanks and Regards
Venkatesh S
Application Engineer
E G S Computers India Pvt. Ltd.
http://www.egsindia.com | http://www.egs.co.in | http://www.egsindia.blogspot.in