AnsweredAssumed Answered

Wrapping a "real" label on a conical surface

Question asked by Andrew Kronquist on Jun 17, 2015
Latest reply on Jun 17, 2015 by Tom dunn

I'm trying to figure out how to make a label that will wrap on a conical surface. So far I'm stumped. The real label on the real part ends up looking like it's arcing when it is applied. Not good for long labels, but OK for shorter ones. Usually I make labels .236 (6mm) wide X .005" thick with some variable length. Any ideas?

Thanks!

 

IMG_1998.JPG

Outcomes