AnsweredAssumed Answered

I can't bevel these Structural Members

Question asked by Vagulus Dagg on Jun 16, 2015
Latest reply on Jul 12, 2015 by Vagulus Dagg

When I insert a Structural Member into a Weldment I don't get the option to set the joint profile.  I wind up with something like this

2015-06-16_16-44-48-Trim_Problem.png

Here the longitudnal and vertical members aren't trimmed to the crossmember (1), and the diagonal brace isn't bevelled.  If I use Trim/Extend either the crossmember overhang is removed (at the square joint) or the crossmember is extended and bevelled at the angle joint.

 

This never happens in the movies! 

 

What have I done wrong?

 

P.S. I'm sorry the Structural Member sequence is a bit of a dog's breakfast, but I got into trouble by inserting most of the members then trying to change the profile locations.

Outcomes