AnsweredAssumed Answered

PLC Creation

Question asked by Robert Degiorgio on Jun 12, 2015
Latest reply on Jul 2, 2015 by Tom Evans

I have a relay module wirth one ordering part number which has a lot of 24pin slots (13 slots). These are all the same. (see figure below)

 

 

c264 rear.jpg

 

I would like to create just one slot then reuse it for all the other slots. I do not want the manufacturing component to show all the cards but just the ordering part number only in the BOM. How do this.

Any ideas how i might do this.

 

Thanks

Outcomes