OK, so I am trying to get this drawing to where a coworker cna print it off but it is only giving a small section in the bottom left corner to print. When I open the file is Solidworks (2015) it shows a tan-ish rectangle in that corner. I'm assuming that that is the area designated for 1 sheet. Is there a way I can scale the drawing or the page so that the full drawing can be on one page?
Right click on the tan-ish rectangle, select properties and change the scale.
Thanks. I figured it out like 2 minetes after I posted the question and then couldn't find my question to remove it -_-
"......then couldn't find my question to remove it"
https://forum.solidworks.com/content?filterID=contentstatus%5Bpublished%5D
I have another question about a different drawing. It's the same issue but part of the drawing isn't scaling with the rest of it, and when I finally got it to, it automatically moved to a weird position.
Was it text? I've had the same problem and just move it into position accordingly.
it's not text, its an actuall part of the drawing that is being weird
Right click on the tan-ish rectangle, select properties and change the scale.