5 Replies Latest reply on Jun 9, 2015 3:50 PM by Jeff Mirisola

    solidwork glitch, mashed graphics

    Tim DO

      Hello everyone, I'm new to Solidworks and have no idea what I'm doing wrong with these two "parts" I put together in an assembly.

       

      The parts file were two separate assemblies, (Circuit Board) and (Chassis).

       

      Basically the Circuit board is where the problems start, in assembly mode and part mode alone - the circuit board was fine.

      But when I mate it to the chassis, some of the parts on the board begin to "disappear" or have some weird physics on it and the linear pattern merges into the green board.

       

      Here are the attached pictures of them (One pre-assembled and one assembled onto the chassis)

       

      Thanks to those who can answer/help me with this!