AnsweredAssumed Answered

Lofting between two individual splines

Question asked by Eric Neil on Jun 5, 2015
Latest reply on Jun 6, 2015 by Eric Neil

Hi there, I'm brand new to Solidworks and am trying to do some lofting of two splines to begin making a boat hull. Whenever loft between my two splines however the loft goes along one profile like I want it to but then only touches the other profile at a single point rather than along the whole spline. Any suggestions on how to make the loft act over both whole profiles? The attached picture shows what I mean. I am clicking "Lofted Boss/Base" to get to this menu.

 

Thanks!

 

Outcomes