5 Replies Latest reply on Jun 5, 2015 2:51 AM by Deepak Gupta

    property from the part into the drawing and then one to create a PDF with the part number (pulled from the part macro), description, and REV. I am to pull the component part number form the part custom properties and use it in the creation of a PDF in the

    Aaron Clarke

      Hello,

       

      I am hoping some can help!

       

      We currently have 2 macros one to pull the property from the part into the drawing and then one to create a PDF with the part number (pulled from the part), description, and REV. I would like to pull the component part number form the part custom properties and use it in the creation of a PDF in the drawing.

      I'm sure this or very similar has been asked many times so my apologizes.