4 Replies Latest reply on Jun 2, 2015 8:45 AM by Nick Poweruser

    How to call-out a helical cut in a drawing.

    Nick Poweruser

      I am trying to call-out a helical cut in a drawing....This can be seen below via attachment.

       

      The plane that I sketched on is normal to the start of the helical sweep and can be seen below as well.

       

      Initially I was going to specify the radius of the helix and the pitch of the helix but I am not too sure that would work with the plane that is angled.

       

      Any ideas?

       

      Thanks for your time,

       

      Nick