i want to create a sweep with a sketch that has for height the same that has for pitch (0.125 IN) my curve how you can see.
But this is not possible, in the last photo says something like that: reconstruction mistake, is impossible complete the operación.
i belive that is for thickness Zero. what can we do for resolve that?
If i were to guess, I'd say your profile sketch overlaps itself in the helix.
i belive the same because if i reduce the height of the sketch (.120 IN) IS POSSIBLE CREATE THE SWEEP.
THEN.... IS NOT POSSIBLE CREATE A SWEEP WITH THE SAME HEIGHT WITH SKETCH AND CURVE??
WHICH WILL IT THE SOLUTION?
Maybe you can make it almost the same height like .12499 and then it might be successful and will be good enough for your purposes.
I don't think you can have the height of your profile be the same as or greater than the pitch of your helix. I think you're right that it's a zero thickness geometry issue. Can you set the height to .124 or .1245 (so that dimensioning it to three decimal places rounds it up to .125)? Even .0001 less would probably be enough. The best work around is going to depend on the way you do things at your particular workplace though. Best luck,
Matt
I TRIED WITH 1.249 AND IS POSSIBLE CREATE THE SWEEP.
THANK YOU FOR YOUR ANSWERS. I DONT KNOW WHO PUT LIKE CORRECT ANSWER.
Maybe you can make it almost the same height like .12499 and then it might be successful and will be good enough for your purposes.