Hi again,
Another question I have for today is the section view. What I notice is my section view won't work if I want to use it on my large assembly. Any advice?
KN
Hi again,
Another question I have for today is the section view. What I notice is my section view won't work if I want to use it on my large assembly. Any advice?
KN
It is an assembly with a message but I'll try to make a screenshot soon.
From the preview where there is a section plane with the double arrow to adjust the depth of the section. I can adjust the depth I want to cut. But once I click the green check I get the following message:
" The model could not be properly sectioned by the section line.
Please check that the section line cuts through the model."
You have a zero thickness condition. Try to use the graphic only option for the section.
Is there an option to choose graphic only somewhere that I don't see?
Alin, I don't have that option. I am using SW 13.
Then you need to cheat a bit. Move the section plane about a micron.
Any error message?
Is it assembly or drawing environment?
Sometimes the problem is tangency.
You can also improve assembly structure (tree).
Steve