1 Reply Latest reply on May 26, 2015 7:40 AM by Peter Cram

    Is it possible to use a discription of an part in an assembly drawing?

    Marijn Van Den Heuvel

      I have a product that uses a bulk-product. This end-product (assembly) needs to be marked with the information of this bulk-product.

      On the drawing there need to be marking instruction that refere to the bulk product.

      The bulk product is an solidworks part that is made out of a design table.

      The description of the bulk part is in the BOM.

      Now my issue is.

      So in short:

      I need to use the config-description of the part in the marking instruction of the assembly drawing.

      Is this possible without doing it manual and without adding a extra view of the part in the drawing?