When I make a section cut it creates the view but nothing is displayed in the view?? Anyone else have this issue or know what is going on?
So I got it to work, initially I was projecting views up from the main view to get the proper section cut needed. The work around I had to do was to position the model and insert "current model view" into the drawing and align it with the top view. I then added the section cut the way John mentioned and it worked.
Try pressing ctrl+q. If that doesn't work can you attach the part and the drawing here?
I have tried ctrl+q that didn't work. I have attached the model and drawing.
Sorry, I don't have SW2015 so I can't open the files. The only thing I can think of is to check the drawing view properties for the section view and go to the Hide/Show Bodies tab and make sure the part body isn't listed there.
Dennis, I had to delete your view and add section view - Did you use this to start ?
John, initially I did not create it that way. I sketched a line then selected the line to be sectioned.
I did try the way you suggested and still had the same problem.
I tried to just sketch a line or rather two lines to make one section, didn't work.. Then I used what I show and it worked...
Did you delete the view and re-insert..
That's strange, I did the same thing and nothing changed for me.
I did re-insert and I also tried making a new drawing and still the same issue.
Retrieving data ...