Having an issue with converting points in a drawing.  I am not understanding something.

What I need is to determine the angles of all the holes attached to a center mark.  Right now, the macro correctly locates all the holes associated to the center mark.  I'm trying to place a construction line between the center of the bolt circle and the center of each hole.  It is starting the line in the correct location (0, 0, 0), but the end point is in never-never-land.

The macro needs a center mark (bolt circle) selection before starting the macro.  I have commented out the "CreateLine" sub because I was still working on the transformation.

Thanks - Dave