AnsweredAssumed Answered

Change Default Coordinate System

Question asked by Kevin Redekop on May 14, 2015

Probably if I dig deeper, I may find this answered, but so far I have not found what I am looking for.


Is there a way to change the default or system established coordinate system?  This is what it is currently...



This is what I need it to look like. In order to have the parts import correctly into my nesting software for our laser.



I know I can create a new Coordinate system, but when I do that, I cannot get the system to create a sketch on new part open after saving this new coordinate system to my template.


Any solutions or idea's would be greatly appreciated.