I have created the panel assembly below and insert it in a project. When I want to route the wire error below appear. Can any one help me with this issue.
You don't actually have to clear all the errors to route wire. If your wires are not routing it may be for something else.
You can only "Route Wires" if none of your wires are associated to cables or harnesses.
You can only "Route Cables" if your wires are associated to cables and not harnesses.
I have yet to get the "Route Harness" to work (I think its faulty)
As for that particular error. I think SWE only wants you to assign 3D Parts (not 3D Assembliesy) to MFG Parts. I have run into that same error, the trouble I had was after I removed the assembly from the part association it still threw the same error.
But again, I don't think you have to clear it to route wires.
Thank you for the information. As for me as long as the terminals are connected it's fine. Just that the errors make it unperfect and for peoples (eg. management) don't know about Solidworks thinks that you are not as what they expected.
Retrieving data ...