AnsweredAssumed Answered

Need some help forming a ferrule as a sheet metal part.

Question asked by Andrew Combs on May 11, 2015

The manufacturing process is simple:

*Take a flat blank and roll it into a cylinder.

*Using a die, swage the cylinder by pressing one side of it into the die. (I can do the necessary operations separately in solidworks, but not together. I would like to do this in sheet metal so I can use the cut out blank for the 2D drawing.)


The above image is with the shoulder rolled with @ R.25.


and this is the rolled cylinder (4.750 ID) I am drawing a blank on how to do this. If I need to upload the .sldprt blank, just let me know.