AnsweredAssumed Answered

Converting to sheet metal

Question asked by David Boydston on May 6, 2015
Latest reply on May 7, 2015 by David Boydston

I have a question about converting into sheet metal, most of the tutorials I've seen start out with rectangular features and with the final shape almost complete.


I have the attached image that needs to be done.


The way I did it was to first extrude an arc on the front plane and then make a cut on the top plane to make it look like that.

I would like to make this a sheet metal part, however the whole part is a giant bend, it doesn thave "small bends" so I am confused as to how to go and do this.


The part is going to be used as a very weak spring, which is why i need it to have its fixed curvature.