3 Replies Latest reply on May 2, 2015 7:27 PM by Robert Conklin

    Calloutformat.txt file & the proper drawing callout for screw holes vs plain?

    Robert Conklin

      How do I get the proper drawing callout for the 5.5mm holes shown?

      When I place a screw clearance hole in the model why can I not get it

      to use <hw-fstsze>  for only the screw clearance hole.

      for a plain hole I do not want the  <hw-fstsze>  call out

      BUT where is there in the calloutformat.txt file a place for the

      ************************************

      *        screw clearance         *

      ************************************

      cannot find it in my call out format txt file

       

      see attached files

       

      M5 CLEARANCE vs 5.5 DIA HOLE MODEL.JPG

      M5 CLEARANCE vs 5.5 DIA HOLE MODEL.JPG

      M5 CLEARANCE vs 5.5 DIA HOLE AND CALLOUTFORMAT.TXT FILE.JPG

      M5 CLEARANCE vs 5.5 DIA HOLE AND CALLOUTFORMAT.TXT FILE.JPG

      M5 CLEARANCE vs 5.5 DIA HOLE DRAWING.JPG

      M5 CLEARANCE vs 5.5 DIA HOLE DRAWING.JPG