Hi all, really apprecite if someone could help adding the 3 countersunk type holes to this part, unsure which settings to use.
2d drawing is attached and file.
Also any other criticism is very much appreciated on the modeling.
Insert>Fastening Feature>Mounting Boss
Check carefully - I left some work for you to figure out.
That's awesome, I've never seen that tool before.
Thanks J mather as always
Would either yourself or jamil be able to help adding them. still getting them wrong.
woulld be appreciated.
I was surprised that you didn't come back right away asking more questions - as the first time through creating plastic fastening features can be tricky.
Attach your attempt here, and then once I see where you are getting stuck I will post step-by-step instructions. (Did your instructor cover this topic? Miss a class?)
It has been a while now - and no response?
Is the assignment past due?
I am used to rapid back-and-forth discussion to arrive at problem solutions and quickly lose interest when there is no feedback response.
Apolagise J Mather, I had internet access problems at home the past few days, would be grateful for your assistance getting these holes correct. I have uploaded a file for your review, I have done my best interpreting the dimesions however locating them is my downfall.
Sketch14 is not fully constrained - this topic (fully constraining sketches) should be covered long before getting to a part of this complexity.
Edit Sketch14, fully constrain and add a circle to the third point (see image) as you have done for the other two.
Make sure you make these active in each of the following steps -
Edit Mounting Boss5 and select the face shown to orient the axis of the boss perpendicular to the face (you will have to Flip the direction).
Select the sketch circle for the Concentric Reference.
You should now be able to figure out how to align the other two bosses.
Hello AM (?)
It appears J Mather has more knowledge about plastics than I but I did manage to place the fastener features properly (I think). Check out the attached model. I added a vertical sketch before the mounting bosses so I could assign a direction for them. Also fully defined the 3d sketches on surface. There are some errors in your model. Not going to go through them all but I will point out a few. The obround (slot) in the side is not positioned correctly in the x. The cutout goes through both walls, s/b one. The cutout on the right end is not dimensioned correctly. (30mm)... Check your boss on the left end. Don't think it should be angled upward.
Review your entire model and enjoy your day.
Retrieving data ...