Help, I have lost a Template Path
No place I try will work. Not sure in the first place why I am having this issue but I try to pick a path and SolidWorks won't accept any of them.
-
-
-
Re: Help, I have lost a Template Path
I am attempting to route Pipe. I have no problem routing tube, but SW crashes when ever I rout pipe. Also, no Pipe shows up in my assembly, only the line. In a tube routing the tube/line both show as I route them.
-
-
-
Re: Help, I have lost a Template Path
Are your default templates are being shared from network location ?
Kindly go System Options<Routing File Locations<Launch Routing Library Manager.
Check the default path of templates/Pipes .
-
-
Re: Help, I have lost a Template Path
Was able to the get the first dialog
box to not pop up so I suppose I add a path correctly but still when I attempt to start a pipe routing my whole assembly goes to wire mode and nothing but a line for a stub shows up. -
Re: Help, I have lost a Template Path
All of this was routed to my old 2013 files, then I hit the Load Default button and it changed it to all 2015. But nothing changed, still doesn't work.
-
-
-
Re: Help, I have lost a Template Path
Try resetting the routing library manager.
Click on Load Default & Save settings.
Close the Library Manager.
Try creating route again.
Thanks,
R.Vignesh
-
Re: Help, I have lost a Template Path
Thats what I did and all the paths went to what you see in the above screenshot showing paths to my 2015 SW folders. Same issues area happening. Everytime I create a Pipe routing and click out of the edit mode SW crashes. If I create a tube routing it does not crash.
-
