3 Replies Latest reply on Apr 24, 2015 7:56 PM by Jared Conway

    How would I set up a water quench in flow simulation?

    Eric Vande Ven

      Hello,

       

      I was wondering how I would set this up in Solidworks flow simulation.  I want to simulate a hot aluminum casting being dunked into water.  So there would be an initial movement of water across the casting as it is dunked into the water, then have it sit the water with no movement of the casting.  Would this be possible to do without starting out with the casting being fully immersed in the water? 

       

      Thanks,