0 Replies Latest reply on Apr 13, 2015 10:18 PM by Sam Smk

    Gear puller jaw simulation

    Sam Smk

      Can anyone do help me do this?

      We were asked to draw a gear puller (and I have already made one)

      Now we are asked to do a (Stress/strain simulation of one of the jaws assuming a force of 1500N is required to remove a 40mm diameter gear from a 20mm diameter shaft, if both are made of steel and are shrink fit?)

       

       

       

       

      P.S

      I have played with jaw trying to do the simulation so I might have missed it up.