14 Replies Latest reply on Jun 14, 2016 1:51 PM by Shawn Grigsby

    Not able to drag Section Line

    Dennis Schuette

      I am not able to drag the Section Line after it is inserted into a drawing view.


      I created the section partial section cut by sketching a line, selecting the line for the section cut.


      When I edit the sketched line I am not able to drag the end points or even move the line to adjust the section line.


      I did see a thread on this from about 3 years ago and I made sure the solution that helped that person wasn't the case here.


      I am running SW2015 SP 1.1