0 Replies Latest reply on Mar 27, 2015 10:26 AM by Alexandr Buganov

    Is it possible to draw wire body not over the entire geometry ?

    Alexandr Buganov

      Hi Everybody!

       

      Here is my question...

       

      When you create a wire body by corresponding SW API it is always drawn by SolidWorks at the top of all other geometry (see attached screenshot - three yellow rectangles there are wire bodies). Is it possible to change this behavior (i.e. some parts of the yellow rectangles should not be displayed as they are behind the solid part)? Or possibly there are some other ways to show temporary lines / curves in SolidWorks in addition to wire bodies ?

       

      Thanks in advance,

      Alex

      wire body.png