AnsweredAssumed Answered

Toolbox components in an assembly, error when reopening the assembly?

Question asked by Eric Salvo on Mar 24, 2015
Latest reply on Mar 24, 2015 by Deepak Gupta

Whenever I use a toolbox component, such as lengths of aluminum angle, errors happen when I reopen the assembly later. The pieces of aluminum angle will open without any holes or cutouts and that messes up mates and sketches on other parts. However, if I open each piece of angle separately first and then open the assembly it is fine. What is causing this issue? I tried "pack and go" to a new assembly to try to break any references outside of the assembly, but that did not work. The answer is probably simple, but I can't figure it out.

Outcomes