8 Replies Latest reply on Mar 19, 2015 2:06 PM by John Lennon

    how can i knit 2 surfaces with a gap greater than 0.1mm?

    John Lennon

      i am designing a motorbike fairing for a school project however when i came to thicken the surface to 3d print i got an error, possibly to do with there being gaps in the surface? when i checked the surface knit the 2 gaps both exceeded the 0.1mm tolerance and are unable to knit. is there any way around this problem without re-aligning the the edge of the surfaces to reduce the gap.