16 Replies Latest reply on Mar 19, 2015 1:37 PM by Jean-Baptiste Bouckaert

    When modelling complex surfaces with projected curves, solidworks selection manager doesnt work properly. I'm using SW 2015 SP2.1, early versions did work well

    Alex Dariel Pallares

      Hi everyone

       

      I recently upgraded to Solidworks 2015 SP 2.1 and started to work with surfaces. I created some projected curves and I was about to use loft surface, and when i tried to use the selection manager (drums intro), it didnt work. It doesnt let you pick any of the projected curves.

       

      problem.jpg

       

      Has anyone experienced this? How can i solve it, without downgrading solidworks to previous versions?

       

      regards,

       

      Alex P.