In 2014 SP 3.0 I observed the following behavior while trying to align two sketch blocks by applying a collinear relationship to the highlighted horizontal lines pictured below. There is an unexpected ≈18.5 gap between the lines. Has anyone else seen this before?
I see some of your lines are red. Do you get this error in the sketch?
If so then the sketch is over-defined and SW will not solve all of the constraints. You can show relations and see if any are red and try deleting some until the error goes away. Then see if the blocks align.
There is no errors. The lines of the blocks are colored pink, violet, and orange to differentiate them from other blocks I am using.
However, I found my own solution by exiting the sketch and fully rebuilding (ctrl + q) the model. The lines refused to align before I did that.
There is no errors. The lines of the blocks are colored pink, violet, and orange to differentiate them from other blocks I am using.
However, I found my own solution by exiting the sketch and fully rebuilding (ctrl + q) the model. The lines refused to align before I did that.