I will like to apply a force, but the force should only work from 0 til 10mm, and then stop.... is that possible ?
Just like ejecting a part out of a mould tool.
"...but the force should only work from 0 til 10mm..."
Please clarify what you mean by this.
if you have an ejecer on a mould tool, the travel it makes is eksampel 10mm. I would like to simulate these 10 mm of travel.
So you want a defined displacement of 10mm. Or do you want a specific force (i.e. 2pounds), but only up to the 10mm limit?
If you simply want to push something 10mm you would use a displacement instead of a force.
and the only way to turn it off would be to do a nonlinear analysis
i believe this came up about 6 months ago and someoen wrote up the procedure for turning it off and it will be part of solidworks simulation 2016
Retrieving data ...