4 Replies Latest reply on Mar 9, 2015 2:33 PM by Mark Kaiser

    Drafting Injection Mould Tool GA Drawings

    Trevor Sheen

      Just looking for some advice on how to draft injection mould tool General Assembly (GA) drawings.

       

      I want to include a full BOM and enough detail for machinists to understand without over complicating things.

       

      I have seen drawings produced using other software with lines removed etc and they look nice and clear. The issue I find with SW is that it's very time consuming to remove all detail I don't want, therefore just seeking some guidance on ways to carry out the task in hand.

       

      Some examples of what others have produced in SW would be useful.

       

      Thanks.