I am trying to prepare for the exam and need some insight. I'm not looking for an edge or anything but I just wanted to know what to expect.
I found a sample exam with 4 questions but I think there is more to it then that.
Don't remember exactly but something between 18-20 questions.
Totally 19 Questios in that 4 Check mark option [Yes/No].
Thanks and Regards
E G S Computers India Pvt. Ltd.
http://www.egsindia.com | http://www.egs.co.in | http://www.egsindia.blogspot.in
I experienced the test exam to be easy compared to the real exam. I could only finish around the half or two thirds of the 19 questions.
Currently I'm training for a repeat. Have a look at Matthew Perez Camaro Project (@Surface Modeling a Car) if you don't have a lot of surface modeling experience.
Thanks for the reply. I will look at the Camaro project.
A month ago I past the Surfacing exam.
It was the second time I entered the exam, the next topics are known to be treated:
The hardest topics for the surface modeling certification is Practicing Sketch Picture, Loft, Boundary Surface, Trim,Fill,Split And Split line commands, Knit, Thicken, Face to Face fillet. These are some what basic things you have to know for Surface Modeling Certification.
Specially Go through model creation of Mouse, Remote and Instant 3D creation and modification.
That's helpful. I bought a dvd on surfacing and should receive it in the mail shortly. I will practice quite a bit before I attempt the exam.
Retrieving data ...