I have a reality vs. SolidWorks sheet metalquestion. The best corner I can come up with using ClosedCorner is shown in the attached photo. In reality, our sheetmetal fabricator can 'roll the corner' such that the 'tear' onlyoccurs on the vertical line where the two edges meet. Myfabricator is laughing at me because I can't reproduce a print thathe came up with on a napkin (which works). Our customerdoesn't want an open corner and wants the 'rolled corner'. Can SolidWorks reproduce this 'rolled' corner? I hope Iexplained this correctly.
Regards,