I need help with fillet, tryed a long 2 days and redesigned all various times, but i cant make fillet in this solid, tryed solid and surface model, but no suscess
What about your current model do you want different?
I suggest fine-tuning Loft2 and Loft3. Pretty bad quality for the resulted faces.
What do you want to fillet?
I want the smooth transition between lofts, alike picture below
It's not coming out right becuase that's not a single loft.
It's an intersection of a loft, a parabaloid and a collar.
the reason it looks smooth is that the surfaces are very simple without many inflections and gradual change of curvature-everywhere except where they intersect.. then you can can clearly see the fillets that were used to smooth between them. The more profiles and spline points you add to a loft, the more it's going to buck and pinch to pass through the curves.
One of the things you learn as a journeyman trying to become a surfacing master is that an ugly wire frame won't make a beautiful surface.
..an interpreted attempt at the strutbody..https://www.dropbox.com/s/7th8yya1ppapnf4/strutbody-zxys.zip?dl=0
Thank you so much Paul!!!!
How you do it? ...maybe you can make a short tutorial, thank you so much again!
Either add more sketches, or use guide curves.
Tryed make using just one loft with more sketches with and without guide curves, no results. The sketchs of guide curves still in the file.
I can't see any guide curves in the model.
I would try making this as one single loft, instead of 3. I would also radius the two rear corners in the sketch shown below.
Tried make it with a single loft, but without good results, i go post another file with guide curves in some hours.
If you use a single loft it works better if each sketch has the same amount of sketch points, it should work. On the top circle use the split sketch tool to add those points
Also your sketch nodes are not in line and the sketches are splines not a true geometry
I would suggest changing your sketches and adding the sketch points - then your part should come out the way you want it
Here new files using sketch and guide curves, no success yet
New file with more sketchs, but still bad results
I took a look at your model today. I noticed you have too many sketches. You only need to have 4 sketches for sections. Also, your sketches do not have all of your design intents. Lastly, as someone else mentioned, you need (do not have) to make same segment no. of entities on each sections. If you know how surface modelling works, particularly, surface lofts, you will know why your geometry does not allow you do fillet because mathematically it is not possible.
If you think more about design intents, you'll figure how to model this simple geometry.
Good luck and have a nice weekend!
Retrieving data ...